Tripp-Lite B160-101-DPSI El Manual Del Propietario página 15

Point-to-Multipoint Installation –
Managed Switch with IGMP
Do not connect the external power supply to the receiver at
this time. The receiver should not be powered on until all
audio/video equipment is connected and powered on.
14. To connect additional receivers, repeat steps 9 through 13.
15. Power on all connected devices.
16. Connect the external power supplies to all transmitter and receiver
units in the installation, then plug the external power supplies into
Tripp Lite Surge Protectors, Uninterruptible Power Supplies (UPS) or
Power Distribution Units (PDU).
15