brennenstuhl Multi-Test MT 6 S/2 Instrucciones De Empleo página 8

013109 Multi-Test MT 6 S_2_013109 BA_Multi-Test MT 6_S 01.04.16
Operating Instructions
Testing probe
Button
High intensity LED
Screw
Open
Close
ATTENTION:
With the exception of the batteries, never attempt to
remove any components from the device.
Do not use the device if the screw has been removed.
Tighten the screw completely (clockwise).
Prior to Use
Self Test
that the device is functioning correctly.
If this does not happen, stop using the device.
When the LED starts to weaken, the batteries need to
be replaced!
Voltage Test (Alternating Current)
blinking.
Note: For this test method we recommend that you not
touch the screw on the device.
8
Before each use of the device, a self
test must be performed in order to
assure correct function. Just touch
the probe with one hand and the
screw on the device with the other.
The blinking of the LED indicates
(1) direct voltage test
(70-250 VAC)
ATTENTION!
As soon as the probe is in direct
contact with the external conductor
(phase) of electrical outlets, the LED
MT6 S/2