Block Diagram - Laney AUDIOHUB AH110-G2 Manual Del Usuario

BLOCK DIAGRAM

CH1
MIC/LINE
INPUT
MIC
LINE
MIC/LINE
INPUT
MIC
LINE
Bluetooth
FUSE REPLACEMENT AND VOLTAGE SELECTION
Switch off and disconnect the power cord before proceeding.
1.) Slide out the fuse holder tray.
2.) Only replace fuse with the same
type and power rating as specified
on the rear panel.
MIX OUT
6.35MM UNBALANCED JACK 3.5MM STEREO JACK
GND +(HOT) GND RIGHT
110-120V setting
110-120V~
Using a suitable tool, slide the voltage selector switch to the required
operating voltage.
220-240V setting
110-120V~
1/O CONNECTOR
WIRING:
MALE MALE
1 2 2 1
1 GROUND
2 HOT
3 3
3 COLD
(FRONT VIEW) (REAR VIEW)
FEMALE FEMALE
1 1
2 2
1 GROUND
2 HOT
3 3
3 COLD
(FRONT VIEW)
(REAR VIEW)
6.35MM UNBALANCED JACK
GND +(HOT)
3.5MM STEREO JACK
LEFT GND RIGHT
LEFT
220-240V~
VOLTAGE SELECT
220-240V~
VOLTAGE SELECT
9