Safco 1930 Manual De Instrucciones página 2

2
o
Insert a D Screw in the hole at the inside
front of each Leg, but do not tighten com-
pletely; leave about 1/16” gap. Place the
o
E Shelf between the Legs, with the back
flange resting in the bottom flange of the
Modesty Panel, and guide the slots at the
sides of the Shelf behind the Screws. Fas-
ten Shelf to lower corners of the Modesty
Panel with two additional Screws. Now
tighten the front Screws.
3
o
The F Top Panel can be mounted
with either side up; select the side
you prefer, and slide it into the top
channels of the Legs (the cord cut-
out should be facing toward the
o
back). Insert a G Carriage Bolt (with
the square neck) into each square
hole in the Legs, through the Top
Panel, and fasten with a H Barrel
Nut.
Carefully lay the unit on its back. Screw a
4
o
I Glide into the front and back hole of
each Leg. Set the unit upright. Adjust
Glides to make unit level.
ATTENTION:
Please CENTER load over Legs
at rear of unit. Do NOT place
heavy loads at front.
1930-37: 2 of 2; Rev. 1: 03/03
HANG BACK OF SHELF
ON MODESTY PANEL
G
o
H
Safco Products Company, New Hope, MN 55428
E
D
HANG FRONT OF
SHELF ON SCREW
I
F