ASROCK X79 Extreme9 Manual De Instrucciones página 59

4. Click the Create Team tab.
* The Create Team tab appears only if there are teamable adapters available.
5. Click the Team Name field to enter a team name.
6. Click the Team Type field to select a team type.
7. Assign any available adapter or adapters to the team by selecting the adapter
from the Load Balance Members list. There must be at least one adapter
selected in the Load Balance Members list.
8. You can assign any other available adapter to be a standby member by selecting
it from the Standby Member list.
* There must be at least one Broadcom network adapter assigned to the team.
The Large Send Offload (LSO), Checksum Offload (CO), and RSS indicate if
the LSO, CO, and/or RSS properties are supported for the team. The LSO, CO,
and RSS properties are enabled for a team only when all of the members
support and are configured for the feature.
* Adding a network adapter to a team where its driver is disabled may negatively
affect the offloading capabilities of the team. This may have an impact on the
team's performance. Therefore, it is recommended that only driver-enabled
network adapters be added as members to a team.
ASRock X79 Extreme9 Motherboard
59