Hardware Installation; English - Air Live WL-5460CAM Guia De Inicio Rapido

Hardware Installation

Attaching the Metal Clip
To attach the metal clip, remove the two rubber pads under the base of the
camera firstly. Place the metal clip onto the camera base, and align the
two holes of metal clip with two screw holes on the camera base. Then,
secure the metal clip with two screws (provided in the package).
There are two ears on each side of the metal clip, allowing the camera to
be mounted on the ceiling or wall using two wall screws (provided in the
package).
Wall screw
Ear
Connecting the Ethernet Cable
Connect an Ethernet cable to the
network cable connector located on
the camera's rear panel, and then
attach it to the network.
Connecting the Power Supply
Attach the external power supply to
the DC power input connector
located on camera's rear panel, and
then connect it to your local power
supply.
TIP: You can confirm power source is
supplied from the Power LED on the
camera is illuminated.
Wireless Pan Tilt MPEG4 Camera
WL-5460CAM
Screw
Screw
Base of the camera
Ear
Wall screw

English

1
1