Tabla de contenido
Publicidad
18
KLARK TEKNIK DN32-DANTE
6. Mixer Setup
The following four M32 screens have to do with confi guring the
DN32-DANTE and the signals to/from the card.
• •
The SETUP/card screen shows a graphic of the DN32-DANTE
card when it has been installed correctly, and off ers advice
on setup.
• •
The SETUP/confi g page selects the synchronisation source
and shows status indicators in the top 'global' area
(which should normally be "C" for DN32-DANTE Card).
• •
The ROUTING/home page allows patching of signals from the
DN32-DANTE card to the Input Channel processing.
(e.g. channel 1-4 on Aux In)
• •
The ROUTING/card out page selects channel blocks that will
be provided to the Dante network controller. (e.g. 8 Local
Outputs and 3 x 8 signals from AES50 Port A)
Note that the Dante network routing must be confi gured
exclusively using the Dante Controller Application for Mac/PC.
The signals that have been routed from the Dante Controller App
to the DN32-DANTE card are available for patching to the input
channel routing on the console's Routing/Home page. Please
Synchronisation
A master word clock source must be selected for the network.
The DN32-DANTE Brooklyn II VCXO clock off ers extremely
low-jitter. In this case the Setup/Confi g page should look like this:
Note that the status bar shows "C: 44K1" and a green light for
proper synchronisation of 44.1 kHz to the card.
The second green light "C: Dante" indicates proper installation of
the DN32-DANTE card. The Dante Controller app confi gures the
network for using the DN32-DANTE VCXO clock in this application.
Quick Start Guide
refer to audinate.com for a comprehensive set of documentation,
FAQ and forum advices on confi guring the Dante Controller and
Dante Virtual Soundcard applications.
19
Publicidad
Tabla de contenido
