Innova 3630 Manual Del Usuario página 4

For double-terminal relays:
relays have two small terminals, labeled "I" (for
ignition) and "S" (for start). Connect one lead from
the Remote Starter Switch to the large terminal to
which the battery is connected. Connect the
remaining lead to the small terminal labeled "S".
SOME RELAYS MAY NOT
HAVE SECOND TERMINAL
FROM
BATTERY
FORD STARTER RELAY CONNECTION
If the small terminals on the starter relay ARE
NOT labeled, refer to your vehicle's service
manual.
For Chrysler vehicles: The starter relay can be
found in one of two different locations.
On some vehicles, the starter relay is located in
the stater motor housing. In these cases, the
Remote Starter Switch is connected to a junction
block on the upper left corner of the firewall. Con-
nect one lead of the Remote Starter Switch to the
large terminal to which the battery cable is con-
nected. Connect the remaining lead to the small
terminal.
FROM
BATTERY
CHRYSLER STARTER RELAY CONNECTION
On some vehicles, the starter relay is similar to
the Ford starter relay. Refer to the section on
Ford vehicles for proper connection.
S I
2
Double-terminal
REMOTE
STARTER SWITCH
REMOTE
STARTER SWITCH