Attention: Ne bloquez pas la ventilation
Rear Panel
10
220-240 VAC
100-120 VAC
50/60HZ
30 WATTS
CONSUMO DE ENERGIA 30WH
8
THIS DEVICE COMPLIES WITH PART 15 OF THE FCC RULES.
OPERATION IS SUBJECT TO THE FOLLOWING TWO CONDITIONS
(8) AC POWER INLET
(1) THIS DEVICE MAY NOT CAUSE HARMFUL INTERFERENCE, AND
(2) THIS DEVICE MUST ACCEPT ANY INTERFERENCE RECEIVED,
This is the receptacle for an IEC line cord, which provides AC power to the unit. Connect the line cord to
INCLUDING INTERFERENCE THAT MAY CAUSE UNDESIRED OPERATION.
this connector to provide power to the unit. Damage to the equipment may result if improper line voltage
is used. (See line voltage marking on unit).
Never break off the ground pin on any equipment. It is provided for your safety. If the outlet used does not
have a ground pin, a suitable grounding adapter should be used and the third wire should be grounded
properly. To prevent risk of shock or fire hazard, always make sure that the amplifier and all associated
equipment is properly grounded.
(9) ON-OFF SWITCH
This rocker switch supplies AC power to the amplifier when switched to the ON position. The ON position is
with the right side of the switch pushed "in" or nearly flush with the rear panel.
(10) LINE VOLTAGE SELECT SWITCH
This selector switch allows the amplifier to be operated at different line voltages. Please be sure this switch
is set to the proper voltage for your area before connecting the amplifier to a power source or turning the
amplifier on for the first time. NEVER CHANGE THE POSITION OF THIS SWITCH WHILE THE
AMPLIFIER IS TURNED ON.
(11) Speaker/headphone switch
(12) SPEAKER OUTPUT
This ¼" mono jack is provided for connection of an external speaker cabinet. Minimum load impedance is 4
Ohms.
Please note that this a BRIDGED amplifier output, meaning the sleeve of the 1/4" jack is driven by an amplifier.
Neither the tip nor sleeve of the speaker plug should ever contact ground, or damage could occur! Also, please
use only cabinets built with professional-quality bass guitar musical instrument loudspeakers.
Be aware that the protection circuitry within the ELF will detect overexcursion events caused by inferior
speakers and guitar speakers, which are not meant for bass. The protection circuits will react to these events
by momentarily interrupting the sound. If you experience interruptions, it means the speaker is exceeding
maximum excursion. As an option, reduce the volume. If this happens repeatedly, ultimately you must change
to a professional bass cabinet with adequate suspension and excursion for bass.
--Apparatets stikprop skal tilsluttes en stikkontakt med jord,
som giver forbindelse til stikproppens jord. (For Denmark Only)
--Laite on liitettävä suojamaadoituskoskettimilla varustettuun
pistorasiaan. (For Finland Only)
--Apparatet må tilkoples jordet stikkontakt. (For Norway Only)
--Apparaten skall anslutas till jordat uttag. (For Sweden Only)
ON
SELECT
POWER
CAN-ICES-3(B)/NMB-3(B)
9
11
SPEAKER
OUTPUT
EARTH
LIFT
CLASS 2 WIRING
8OHM MIN. LOAD / 200W RMS
CAUTION: BRIDGED SPEAKER OUTPUT.
SPEAKER NEGATIVE IS LIVE AND
MUST BE ISOLATED FROM CHASSIS.
DO NOT TOUCH ¼" JACK PLUG
12
WHILE AMPLIFIER IS OPERATING.
PRUDENCE: PRODUCTION DE SPEAKER
CONSTRUITE UN PONT. LE SPEAKER NEGATIF
EST VIVANT ET DOIT SOYEZ ISOLES DES CHASSIS.
NE TOUCHEZ PAS ¼" LA PRISE DE COURANT
DE CRIC PENDANT QUE L'AMPLIFICATEUR OPERA.
1x8 COMBO
DIRECT OUT
13
14
DESIGNED IN
THE UK and U.S.A
MADE IN CHINA
5