Ilox SLS-1+ Manual De Instrucciones página 6

n Example: Entering a minimum value of 15 (= 15 %)
n Example: Entering a shut-off delay of 5 minutes (= 5)
For checking purposes, the currently set minimum value or the MIN shut-off
delay are always shown on the red display when the »DIM-MIN« menu option
is being selected during auto mode.
6. DIM MAX (maximum value of brightness)
For the analogue control signal, a maximum value (maximum brightness from
2–100%) can be set at menu item »DIM MAX« by using the turn & press knob:
n Example: input of a minimum value of 85 (= 85%).
When menu item »DIM MAX« is selected in the automatic mode, you will see
the programmed value for control purposes.
7. ADD-RELAY (switch point for additional relay)
With menu item »ADD RELAY«, if needed, an extra relay switch contact (terminal
23/24) can be activated for e.g. the on/off switch of additional light groups
by using the turn & press knob. The relay will be activated or de-activated
depending on the programmed value compared to the actual brightness
(input »OFF« (not used) or »1–100%« is possible).
n Example: input 35 (= 35%).
When menu item »ADD-RELAY« is selected in the automatic mode, you will see
the programmed value for control purposes.
8. MAN (manual control of brightness)
By using the turn & press knob in menu »MAN« the controller can be activated (input
from 1–100% possible). The input value »0« means light (master relay) entirely off:
n Example: input 50 (= 50%)
6