Recommendations For Use - TUBESCA-COMABI X-Tenso Instrucciones De Utilizacion

b. You will also hear a "click" when the locking pins spring into
position.
c. WARNING: If you cannot see any green indicator on either side of
the steps you have opened – DO NOT CLIMB ON THE LADDER
d. Never work when standing on the top three steps (Figure 4) and
make sure that the ladder is at least one metre higher than the
step on which you are standing (Fig. 3).
2.2.c Storing the ladder:
Take special care when you close your ladder. Never put any part of your
body (hands, fingers or thumbs) on, or between the steps or connecting
elements located above the step that you are in the process of closing
(Diagram 3).
1) The "X-TENSO" ladder possesses a "soft closing" system, which makes
each step close gently.
2) Hold the ladder vertically as shown in Fig. 6. Make sure that you are
on a flat, firm surface.
3) Put your thumbs on the unlocking mechanism on the second step
from the bottom (Figure 5). Depending on the model you are using,
push each unlocking mechanism either inwards or upwards for
unlocking the ladder (Fig. 6).
a. The whole ladder is now unlocked (DO NOT CLIMB ON THE
LADDER AFTER CARRYING OUT THIS OPERATION).
b. With the "soft closing" system you may need to guide the steps
down gently when closing the ladder.
c. Close the base by pushing it towards the inside of the ladder until
it clicks into position, then attach the strap for holding the ladder
in its "storage position".
STORE THE LADDER IN THE UPRIGHT RETRACTED POSITION.
2.3 Positioning the ladder:
- Always place the ladder with the unlocking mechanisms on the side
of the ladder towards you.
- It is extremely IMPORTANT for the ladder to be used at an angle of
approximately 75° in relation to the ground. It is dangerous to use
the ladder at other angles.
- The ladder must always be used on a flat, firm surface.
- The ladder must always be leant against a firm solid surface and it
must be secured before use.
- The ladder must always stand on its feet and not on the steps.
- Do not use the ladder on an incline or unstable surface.
2.4 Recommendations for use:
- Instructions MUST be read before use.
- Inspect the product visually before use.
- The surfaces on which the product is standing must only
be horizontal and non-slip.
- Do not deploy the ladder when you are standing or
climbing on it.
- Take all necessary precautions for preventing any non-
authorised person from using the product.
- Make sure that you are wearing shoes that give you a firm footing.
- The maximum load allowed on the product must be no more than 150 kg.
- Only one person must climb on the ladder at the same time.
102-61029/410 - REV. 3 - 05-2020
fig. 5
Warning:
Risk of Falling
7
BARREAUX NON DÉPLOYÉS
BARREAU LE PLUS HAUT
VERROUILLÉ
Diagram 3
BARREAUX NON DÉPLOYÉS
BARREAU LE PLUS HAUT
BARREAUX NON DÉPLOYÉS VERROUILLÉ
BARREAU LE PLUS HAUT
VERROUILLÉ
fig. 6
C A U T I O N
USER AREA
Hold the scale
with this label facing you
SET UP LADDER PROPERLY
TO REDUCE SLIP AND
OVERLOAD HAZARDS.
FOLLOW THESE
INSTRUCTIONS.
SECURE LOCKS
FOR ALL OPENED
SECTIONS.
➀ PLACEZ VOS PIEDS CONTRE
LES MONTANTS DE L'ÉCHELLE.
➁ TENEZ-VOUS DROIT.
➂ TENDEZ LES BRAS DEVANT VOUS.
➃ LES PAUMES DES MAINS
DOIVENT TOUCHER LE BARREAU
À HAUTEUR DE VOTRE ÉPAULE.
➊ NE VOUS PENCHEZ PAS
RESTEZ BIEN CENTRÉ
ENTRE LES MONTANTS.
➋ DÉPLOYEZ L'ÉCHELLE
AU MINIMUM 90 cm