Publicidad
Idiomas disponibles
Idiomas disponibles
OPERATION
01. Release the lever to let the 'rack'
slide to the end.
03. Insert your chosen 'former segment'
into the rack and turn the sliding
piece to the size you want the tube
to bend.
05. Bend the tube to angle needed.
02. Put 'crossbar' on the groove of the
bender and lock the wing nut at the
bottom of the bender.
04. Insert the tube into 'former segment',
press the lever and let 'rack' move
forward to start bending.
06. Release the lever by pulling it down to
allow the 'former segment' to pull back
and take tube out.
3
Publicidad
