Replacing The Gel Film; Disposal; Technical Specifications - Beurer EM 25 Manual De Usuario

Important note!
• Switch off the glute toning device before removing it.
• Replace the batteries if they are low.
• The device will only work if there is sufficient contact
with the skin. If the device is not pressed on there will
be no stimulation.
• Do not use the glute toning device more than once per day.
• In the event of continuous beeping, shut down the
device. Clean the gel film and try to restart the program.
If the continuous beeping persists, replace the gel film.
• If the adhesive capability of the gel film decreases,
replace immediately. Do not use the glute toning device
again until the gel film has been replaced. Otherwise
the unequal distribution of the gel film could lead to skin
lesions.
• In the event of unpleasant current peaks, switch off the
glute toning device and clean the gel film.

4. Replacing the gel film

1. Fully remove the old, used gel film [5].
2. Carefully remove the blue protective
film [3].
3. Carefully attach the gel film to the glute
toning device and detach the protective
film. Ensure that the edge of the gel film does not
protrude over the glute toning device [4].
WARNING!
Make sure that you attach the gel film to the device on
the side where the blue protective film was, otherwise the
skin could become irritated.

5. Disposal

The empty, completely flat batteries must be disposed of
through specially designated collection boxes, recycling
points or electronics retailers. You are legally required to
dispose of the batteries.
The codes below are printed on batteries containing
harmful substances:
Pb = Battery contains lead,
Cd = Battery contains cadmium,
Hg = Battery contains mercury.
For environmental reasons, do not dispose of
the device in the household waste at the end of its
useful life. Dispose of the unit at a suitable local
collection or recycling point. Dispose of the device
in accordance with EC Directive – WEEE (Waste
Electrical and Electronic Equipment). If you have any
questions, please contact the local authorities responsible
for waste disposal.
5

6. Technical specifications

Type
Output wave
form
Pulse length 400 μs
Pulse
frequency
Output
voltage
Output
current
16
EM 25 glute toning device
Biphasic rectangular pulse
4-50 Hz
max. 90 vpp (1000 ohm)
max. 90 mApp (1000 ohm)