Technical Details - Lampa 74503 Manual Del Usuario

GB
PARKING SENSOR SYSTEM
1 Sensor
2 Digital display and audible
warning signal
3 Control box

TECHNICAL DETAILS:

• During reverse motion, the 4 sensors start signalling the presence of obstacles or pedestrians starting
from 250 cm distance.
• The distance from the obstacle is shown on the 3-colour-LED-display with a 5-steps-sequence to indicate
the changing distance from the obstacle both from right and left side of the car.
A multi-toned sound signal warns about the presence of an obstacle.
• Voltage: 12 Volt.
• Use temperature: -40°C / + 80°C
• Absorption: 4W (max)
INSTALLATION:
1 Place the sensors between 50 and 80 cm from
the ground to grant a correct working. Minimum
distance between the sensors should be not less than
30 cm and not more than 80 cm. We recommend to
keep the same distance between the sensors in order
to enable a perfect functioning of the device.
2 Use a measuring tape and an erasable marker to
mark the position of the first sensor at 10-12 cm of
distance from the right corner of the rear bumper.
Repeat the same operation with the left corner.
3 Measure the distance between the two side
sensors and divide it by three to find out the location
for the two central sensors. Example: if the length
between the side sensors is 180 cm, the distance of
the two central sensors must be 60 cm (180:3=60 cm).
4 Mount the drill (included in the mounting kit) on
a wrench and drill into the four points previously
marked on the rear bumper.
5 Control unit must be placed inside the vehicle, to
protect it from heat, wet and water sprinkles.
6 The display must be placed in a suitable position on
the dashboard for a perfect visibility and audibility.
2
1
50~80
cm
L L L
1 1 1
3 3 3
L
3
1
1
1