Using Your Blender - Sinbo SMX 2737 Manual De Instrucciones

Batidora con soporte
Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 24
a soft dry cloth.
3. Wipe any excess food particles from the power cord.
4. Immerse the mix bowl, beaters and dough hooks in warm soapy water for complete cleaning.
Then rinse under running water and wipe dry. The beaters and dough hooks may be placed in
the dishwasher.
COOKERY TIPS
1. Refrigerated ingredients, such as butter and eggs, them should be at room temperature
before mixing begins. Set these ingredients out ahead of time.
2. To eliminate the possibility of shells or deteriorated-off eggs in your recipe, break eggs into
separate container first, then adding to the mixture.
3. Do not over-beat. Be careful that you only mix/blend mixtures until recommended in your
recipe. Fold into dry ingredients only until just combined. Always use the low speed.
4. Climatic conditions. Seasonal temperature changes, temperature of ingredients and their
texture variation from area to area all play a part in the required mixing time and the results
achieved.
5. Always start mixing at lower speed. Gradually increase to the recommended speed as stated
in the recipe.

USING YOUR BLENDER

Before the first use, clean the blender according to the section of "quick cleaning".
The time running unit without load can't exceed 15s. Max operation duration under high speed
per time cannot exceed 1 minute, and 1 minute rest time must be maintained at two consecutive
cycles and 10 minutes rest time must be maintained at two consecutive cycles.
Important: Blades are very sharp, handle with care. Ensure that the hand-held blender is
unplugged from the power outlet before assembling or removing attachments.
1. First pull the door upwards and then hold it in the upper most position while turning in
clockwise the blending rod until tightened. For detaching blending rod, the ejector button is
inactivated, just turning the blending rod in anticlockwise direction and the door would be
released automatically.
2. Simply plug the hand-held blender to power outlet.
3. Dial the speed selector to blending setting?Lower the blending rod into food and depress the
turbo button of the motor unit.
4. To stop the hand-held blender by releasing the turbo button of the motor unit.
CLEANING AND MAINTENANCE
1. Unplug the appliance and remove the detachable stem.
2. Wash the detachable stem under running water, without the use of abrasive cleaner or
detergents. After finishing cleaning the detachable stem, place it upright so that any water
which may have got in, can drain out. The stem is dishwashing safe component.
Note: Do not immerse the detachable stem of the blender in water because overtime the
lubrication on the bearings may wash away.
3. Wipe the motor unit with a damp cloth. Never immerse it in water for cleaning as electric
shock may occur.
4. Dry thoroughly.
Warning: Blades are very sharp, handle with care.
- 9 -

Publicidad

Tabla de contenido
loading

Tabla de contenido