IK iRig PRO Guía Rápida De Inicio página 9

power on by moving the iRig PRO switch (7) to the ON
position and check that the Phantom / MIDI LED (1) has
turned red.
I can't get any sound from my guitar / instrument input.
iRig PRO only works with ¼" MONO plugs guitar cables.
Never use stereo (TRS) plugs cables as the iRig PRO
instrument input will be muted.
Specifications
• Instrument Input: unbalanced, Hi-Z, TS 1/4" Jack, Tip:
signal / Shield: ground
• Instrument Input Level: from 30 mVpp to 6.9 Vpp
• Instrument Input Impedance: 620 kOhms
• Microphone Input: balanced, XLR. Pin 2: hot / Pin 3: cold
/ Pin 1: ground
• Microphone Input Level: from 6 mVpp to 1.4 Vpp
• Microphone Input Impedance: approx 2 kOhms
• Gain Control Range: 47 dB
• Phantom Power: 48V +/-10%
• Input Noise: -97 dB RMS, -105 dB(A)
• Distortion (THD): 0.01%
• Frequency Response: 20Hz-20kHz +/- 0.5 dB
• Conversion: 24-bit A/D
• Sampling Rate: 44.1 and 48 kHz
• Battery: 9V (Alkaline suggested), needed for +48V
phantom only
Warranty
Please visit:
www.ikmultimedia.com/warranty
for the complete warranty policy.
Support and more info
www.ikmultimedia.com/support
Apple is not responsible for the operation of this device or its
compliance with safety and regulatory standards.
WARNING: Permanent hearing loss may occur if earbuds or head-
phones are used at high volume. You can adapt over time to a higher
volume of sound, which may sound normal but can be damaging to
your hearing. Set your device volume to a safe level before that hap-
pens. If you experience ringing in your ears, reduce the volume or
discontinue use of earbuds or headphones with your device.