SilverStone CROWN Serie Manual De Instrucciones página 4

CROWN CROWN 01
1. Loosen the four screws
that secure the top panel.
7. Install hard disk in the bracket
and secure it with screws, there
is room for five hard disk drives.
For CW01-WD
13. Place the bracket with Raptor X
installed back to the front panel
and secures it with four screws
pictured.
19. Then lift the bracket to detach.
03
2. Loosen the four screws that hold
the support brace, and then
remove the support brace.
8. Loosen the six screws that hold
the cooling fan bracket to the
chassis.
14. Place the fans in the fan bracket
and fasten with screws.
20. Take out the optical drive and
the combo drive bracket that
you are going to install.
3. Insert the motherboard standoffs
onto the chassis.
9. Remove the cooling fan bracket.
15. Place the fan bracket with fans
installed back in the chassis and
secure with screws as pictured.
21. Place the optical drive in the
bracket and secure it with screws
as pictured.