SilverStone CROWN Serie Manual De Instrucciones página 5

4. Place the motherboard over
standoffs and make sure
standoffs are securely tightened.
For CW01-WD
10. Loosen the four screws that
secure the Raptor X bracket
16. Place the hard disk drive bracket
with hard disk installed back on
top of cooling fan bracket and
secures it with screws.
22. Place the bracket with optical
drive installed back in the
chassis, secure the bracket with
screws as pictured.
5. Loosen the four screws that hold
the hard disk drive bracket.
For CW01-WD
11. Take out the Raptor X bracket.
17. Loosen the screws that hold the
combo drive bracket in place.
23. Install the power supply.
CW01 / CW01-WD installation complete
6. Take out the hard disk drive
bracket.
For CW01-WD
12. Place the Raptor X in the bracket
and fasten the screws securely.
18. First pull the combo drive
bracket towards the back
panel as pictured.
24. Re-install support brace and
then put the top panel back on
the case and secure it with 4
screws as pictured.
04