Cleaning And Maintenance; Installation And Assembly - DOMPEL Top Make Manual De Instrución

LOCATION OF INSTALLATION
Install your Dompel product in a level place with no grooves or splices, preventing rocking
and vibration. The location must be airy and it must not allow straight sunlight and it must be
product outdoors.
SECURITY
Avoid accidents. After unpacking the product, keep all the packing material far way from
kids.

CLEANING AND MAINTENANCE

Do not use metal spatulas, brushes and cleaning agents such as alcohol, acetone, kerosene,
gasoline, bleach, thinner, solvents, varsol, vinegar or other chemicals or abrasives such as
sandpaper or steel brushes.
To easily clean it, use a solution of warm water with a neutral soap and then wipe dry
carefully. If chemical products reach the upholstery, clean as soon as possible, preventing
the products from staining or drying the fabric. The plastic parts can not be washed with
boiling water. Chromed metal components can be cleaned with a soft, dry flannel, and
silicone-based automotive wax can be used to increase gloss and durability, in this case
perform the task following the wax manufacturer's instructions. Perform periodic cleaning,
accumulated dust affects the beauty of the product making it difficult to clean the product.
IMPORTANT
Never drag the product, if necessary, ask other person's help to remove the product from
the place. Do not place containers with high temperature on your product, at the risk of
damaging plastic parts or the upholstery.

INSTALLATION AND ASSEMBLY

Remove all the components from the package and follow the steps below.
Manually fit the finishing (plastic) cover of the
backrest support (E) on the movable plate of the
seat recline system (A).
Assemble the backrest set (B) on the
seat recline system (A): partially insert the
04 backrest screws (M6 x 30-AB)
pre-fixed on the part (D) using a 4mm
Allen key. After checking the alignment of
the backrest in relation to the seat,
making the final tightening of the screws.
Insert the headrest (D) manually into the
backrest support (B).