Cleaning And Maintenance; Installation And Assembly - DOMPEL SQUARE Manual De Instruccion

ENGLISH
LOCATION OF INSTALLATION
Install your Dompel product in a level place with no grooves or splices, preventing rocking and vibration. The location must be
not install your product outdoors.
SECURITY
Avoid accidents. After unpacking the product, keep all the pack material far away from kids.

CLEANING AND MAINTENANCE

Do not use metal spatulas, brushes and cleaning agents such as alcohol, acetone, kerosene, gasoline, bleach, thinner, solvents,
varsol, vinegar or other chemicals or abrasives such as sandpaper or steel brushes. To easily clean it, use a solution of warm
water with a neutral soap and then wipe dry carefully. If chemical products reach the upholstery, clean as soon as possible,
preventing the products from staining or drying the fabric. The plastic parts can not be washed with boiling water. Chromed
durability. In this case perform the task following the wax manufacturer's instructions. Perform periodic cleaning, accumulated

INSTALLATION AND ASSEMBLY

Remove all volumes from the package, and follow the steps below.
1
2
3
3 - Manually attach (thread) the 04 leveling feet (M) at the
bottom of the base when square base (J).
IMPORTANT:
the feet until the chair is leveled and firmly seated on the floor.
5
7
7 - Position the lever guide on the seat (align
the hole with the seat thread) fixing the screw
(M6 x 30-SX) pre-fixed to the seat (L) using
number 10 wrench.
9
MERELY ILLUSTRATIVE IMAGES.
Products may suffer changes in its components without prior warning. If any questions, contact Dompel.
1 - Fit the handle (G) on the oil pump (F). Attention to the correct assembly position
described on the label attached to the pump. Fasten by tightening the side screws (M8
x 8-SX INT-SC) using an Allen wrench (4 MM).
5 - Manually fit the Finishing
(plastic) Cover (N) of the backrest
to the recline system or fixed
support (K).
8
8 - Assemble the backrest (B) on the reclining system or fixed support (K): partially
insert the 04 backrest screws (M6 x 30AB) pre-fixed to the part (E) using a 4mm Allen
wrench. IMPORTANT: Check the perfect horizontal alignment of the backrest with the
seat before fastening the screws permanently (final tightening).
9 - Assemble the footrest (C)
on the bottom of the seat (A).
Fasten the 02 screws (M6 x
35-SX) pre-fastened to the seat
(E) using a wrench 10.
2- Assemble the oil pump(F) to the base (J) using the washer set (M10)
17. Note: In the square base version, align the handle with one of the
sides of the base as shown in the arrow draw below, preserving better
aesthetics for the product.
IMPORTANT: Do not remove the base protection until the end of the
screw drops or tightening wrenches.
4
4 - Assemble the base set/oil pump (F) to the reclining system
top screw (M10 x 60-SX) (G) using wrench 17.
IMPORTANT:
proceeding to the next assembly step.
6
10
6 - Assemble the seat set (A) on
the recline system or fixed
support (K), gastening the 06
screws (M6 x 30-SX) pre-fixed to
the seat (L) using a wrench 10.
10 - Attach the headrest (D)
to the backrest support (B)
manually.
airy