Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
ensure proper flushing. (See
service instructions.)
Do not install positive
Note:
shut-off devices on valve outlet
or devices that do not allow the
valve to flow at least 1 gpm at 50
psi inlet pressure.
■ Check for leaks around valve
assembly and all pipe fittings.
10)
Set temperature limit stop
screw
The limit stop screw limits valve
handle from being turned to
maximum position resulting in
excessive hot water discharge
temperatures.
■ Place handle on control spindle
and open valve to maximum
desired temperature.
■ Turn limit stop screw clockwise
until it seats. Reference figure 3.
Warning:
adjust limit stop screw
properly may r esult
in serious scalding.
Shower Trim Installation
1)
Attach escutcheon plate
factory
installed
gasket
2)
Attach dome cover
3)
Failure to
4)
Attach handle
Attach escutcheon
Page 3
5)
Attach showerhead
6)
Attach tub spout
Tub & Shower Operation
Control Valve
OFF (rotate handle clockwise)
ON
(rotate handle counterclockwise)
Adjust water temperature
Publicidad
Tabla de contenido
