Noise Information; Vibration Information; Assembly And Adjustment - KRESS KUB60 Manual Del Usuario

Machine Weight
**Voltage measured without workload. Initial battery
voltage reaches maximum of 20 volts. Nominal
voltage is 18 volts.

NOISE INFORMATION

A weighted sound pressure
A weighted sound power
K &K
pA wA
Wear ear protection.
VIBRATION
INFORMATION
Vibration total values (triax vector sum) determined
according to EN 62841:
Vibration emission value:
The declared vibration total value and the declared
noise emission value have been measured in
accordance with a standard test method and may be
used for comparing one tool with another.
The declared vibration total value and the declared
noise emission value may also be used in a preliminary
assessment of exposure.
WARNING: The vibration and noise emissions
during actual use of the power tool can differ
from the declared value depending on the ways
in which the tool is used especially what kind of
workpiece is processed dependant on the following
examples and other variations on how the tool is used:
How the tool is used and the materials being cut or
drilled.
The tool being in good condition and well maintained.
The use of the correct accessory for the tool and
ensuring it is sharp and in good condition.
The tightness of the grip on the handles and if any anti
vibration and noise accessories are used.
And the tool is being used as intended by its design
and these instructions.
This tool may cause hand-arm vibration
syndrome if its use is not adequately managed.
WARNING: To be accurate, an estimation of
exposure level in the actual conditions of use
should also take account of all parts of the operating
cycle such as the times when the tool is switched off
and when it is running idle but not actually doing the
job. This may significantly reduce the exposure level
over the total working period.
Helping to minimise your vibration and noise exposure
1.8 Kg 1.2kg
L = 81,6 dB(A)
pA
L = 92,6 dB(A)
wA
3dB(A)
a = 7,234m/s²
h
Uncertainty K = 1.5 m/s²
risk.
Always use sharp chisels, drills and blades.
Maintain this tool in accordance with these
instructions and keep well lubricated (where
appropriate).
If the tool is to be used regularly then invest in anti
vibration and noise accessories.
Plan your work schedule to spread any high vibration
tool use across a number of days.
ACCESSORIES
Battery pack
(20V 4.0Ah Li battery pack
KAB21)
Charger
(20V 6.0A KAC21)
50mm screwdriver bit
(PH2)
Hook
Bit clip
We recommend that you purchase your accessories
from the same store that sold you the tool. Refer to
the accessory packaging for further details. Store
personnel can assist you and offer advice.
OPERATING
INSTRUCTIONS
NOTE: Before using the tool, read the
instruction book carefully.
Intended Use
This tool is intended for the fastening and loosening of
bolts, nuts and various threaded fasteners. This tool is
not intended for use as a drill.
ASSEMBLY AND OPERATION
ACTION
BEFORE OPERATION
Checking the Battery Pack Condition
Removing the Battery Pack
Charging the Battery Pack
Installing the Battery Pack

ASSEMBLY AND ADJUSTMENT

Assembling the Hook and Bit Clip
Inserting the Bits
KUB60
KUB60.91
KUB60.2
2 /
1 /
1 1
1 1
1 1
FIGURE
See Fig .A1
See Fig. A2
See Fig. A3
See Fig. A4
See Fig. B1,
B2 ,B3, B4
See Fig. C1
9
EN