Publicidad
•
Restrictions of Hazardous Substances (RoHS)
Directive 2011/65/EU. See Disposal and
recycling on page 5 .
A copy of the original declaration of conformity
may be obtained from Axis Communications AB. See
Contact information on page 5 .
Electromagnetic compatibility (EMC)
This equipment has been designed and tested to fulfill
applicable standards for:
•
Radio frequency emission when installed
according to the instructions and used in its
intended environment.
•
Immunity to electrical and electromagnetic
phenomena when installed according to
the instructions and used in its intended
environment.
USA
This equipment has been tested using a shielded
network cable (STP) and found to comply with the
limits for a Class B digital device, pursuant to part 15
of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in
a residential installation. This equipment generates,
uses and can radiate radio frequency energy and,
if not installed and used in accordance with the
instructions, may cause harmful interference to radio
communications. However, there is no guarantee that
interference will not occur in a particular installation.
If this equipment does cause harmful interference
to radio or television reception, which can be
determined by turning the equipment off and on, the
user is encouraged to try to correct the interference
by one or more of the following measures:
•
Reorient or relocate the receiving antenna.
•
Increase the separation between the equipment
and receiver.
•
Connect the equipment into an outlet on a
circuit different from that to which the receiver
is connected.
•
Consult the dealer or an experienced radio/TV
technician for help.
The product shall be connected using a shielded
network cable (STP) that is properly grounded.
Canada
This digital apparatus complies with
CAN ICES-3 (Class B). The product shall be
connected using a shielded network cable (STP)
that is properly grounded. Cet appareil numérique
est conforme à la norme CAN NMB-3 (classe B). Le
produit doit être connecté à l'aide d'un câble réseau
blindé (STP) qui est correctement mis à la terre.
Europe
This digital equipment fulfills the requirements for RF
emission according to the Class B limit of EN 55032.
The product shall be connected using a shielded
network cable (STP) that is properly grounded.
Australia/New Zealand
This digital equipment fulfills the requirements
for RF emission according to the Class B limit of
AS/NZS CISPR 32. The product shall be connected
using a shielded network cable (STP) that is properly
grounded.
Japan
この装置は、クラスB 情報技術装置です。こ
の装置は、家庭環境で使⽤することを⽬ 的
としていますが、この装置がラジオやテレビ
ジョン受信機に近接して使⽤されると、 受信
障害を引き起こすことがあります。 取扱説明
書に従って正しい取り扱いをして下さい。 本
製品は、シールドネットワークケーブル(STP)
を使⽤して接続してください。また適切に
接地してください。
Radio transmission
This equipment may generate or use radio frequency
energy. The user could lose the authority to operate
this equipment if an unauthorized change or
modification is made.
USA
This equipment complies with the limits for a Class B
digital device, pursuant to part 15 of the FCC Rules.
Operation is subject to the following two conditions:
(1) this device may not cause harmful interference,
and (2) this device must accept any interference
received, including interference that may cause
undesirable operation.
This product complies with FCC radiation exposure
limits for an uncontrolled environment. This
equipment shall be installed and operated with a
minimum distance of 20 cm (7.9 in) between the user
and the device.
Canada
This device complies with Industry Canada
licence-exempt RSS standard(s). Operation is subject
to the following two conditions: (1) this device may
not cause interference, and (2) this device must
accept any interference, including interference that
may cause undesired operation of the device.
This product complies with IC radiation exposure
limits for an uncontrolled environment. This
equipment shall be installed and operated with a
minimum distance of 20 cm (7.9 in) between the
user and the device. This device for operation in the
frequency band 5150-5250 MHz is only for indoor
use to reduce the potential for harmful interference
to co-channel mobile satellite systems.
Le présent appareil est conforme aux CNR d'Industrie
Canada applicables aux appareils radio exempts
de licence. L'exploitation est autorisée aux deux
conditions suivantes : (1) l'appareil ne doit pas
produire de brouillage, et (2) l'utilisateur de l'appareil
doit accepter tout brouillage radioélectrique
subi, même si le brouillage est susceptible d'en
compromettre le fonctionnement.
Ce produit est conforme aux limites d'exposition aux
radiations IC pour un environnement non contrôlé.
L'équipement doit être installé et fonctionné à une
distance minimum de 20 cm (7,9 po) entre l'utilisateur
et le dispositif. Dans la bande de fréquences de
5 150 à 5 250 MHz, cet appareil doit uniquement
Publicidad
