Stanley POWERMAX RT901 Manual Del Usuario página 5

To apply the wall mountable remote to the wall, using screws. Disassemble
wall mount until it maches "Figure E". Use a screwdriver to fasten screws in
the indicated areas (Figure 2). Reassemble until it resembles "Figure A".
To apply to the wall mountable remote to an electrical box, disassemble wall
mount until it matches "Figure H". Use a screwdriver to fasten screws in the
indicated areas (Figure 3). Reassemble until it resembles "Figure A".
Notes:
Install in accordance with all national and local electrical codes
Grounding: When no ground is available inside the wall box, the National Electrical Code
(NEC) allows a control to be installed as a replacement if 1) a non-metallic non-combustible
faceplate is used with non-metallic attachment screws or 2) the circuit is protected by a
ground fault circuit interrupter (GFCI). When installing a control according to these methods,
cap or remove the green ground wire before screwing control back into the wall box.
FIGURE 2
FIGURE 3