Silca Air4 Traducción De Las Instrucciones Originales página 4

Ocultar thumbs Ver también para Air4:
Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 31
Air4 Universal Receiver
The installation must be performed in such a way as to provide for all precautions in case of fire or
electric shock. The device is a sub assembled (component). It is the responsability of the manufacturer
or installer of the device in the final system to ensure that the system is safe.
The installation of the appliance must be carried out by expert personnel, or by a person with education
or experience such as to allow the identification of hazards and take appropriate actions to reduce the
risk of injury to themselves and others.
The Air4 Universal Receiver can be installed into old and new automations.
Air4 Universal Receiver comes with an Air4 remote control (frequency 433-868 MHz). The code for the
Air4 Universal Receiver is already memorised on button '1', and buttons 2, 3 and 4 are blank, ready for
memorising remote controls linked to other automations (gates, garages, barriers, etc.)
Where to install Air4 Universal Receivers and why
• On automations where the existing receiver is full (no further remote controls can be memorised).
• On automations where the existing receiver no longer works.
• On automations where the user wishes to transform an old system with a quartz type remote control
into a rolling code type.
• In automations where the original remotes are lost or no longer work.
Installing the Air4 Universal Receiver -
1. Find the gate control unit and open it.
- On sliding gates or barriers the control unit is usually housed in the box containing the electric
motor (Fig.2)
- On swing gates or overhead doors the control unit is usually housed in the box close to the au-
tomation system (Fig.3).
INSTALLATION
Switch off the electricity supply
FIG.2
FIG.3
Copyright Silca S.p.A 2020. All right reserved
E n g l i s h
4

Publicidad

Tabla de contenido
loading

Tabla de contenido