Silca Air4 Traducción De Las Instrucciones Originales página 9

Air4 Universal Receiver
Changing the mode for the two Air4 Universal Receiver outputs (relay 1/relay 2) from default
mode (impulsive) to another.
• Press button 'S' for five seconds in order to enter change configuration for the modes of the two
outputs (relay 1/relay 2); the LED relating to the output setting will flash according to the mode in
which it was programmed.
- LED flashing once: ON/OFF mode
- LED flashing twice: impulsive mode.
- LED flashing three times: Seconds Timer mode
- LED flashing four times: Minutes Timer mode
• Press button 'P' to change mode
• To select the next output, press button 'S' until you leave the output configuration function. To save
the selected settings, always leave the configuration mode by pressing 'S'.
Changing the seconds or minutes timer
• Select one of the two modes to be changed (seconds timer or minutes timer).
• Press button 'S' for approximately 2 seconds, the LED will flash regularly at one second intervals.
• Hold down the button and count the number of flashes to be set as seconds or minutes (e.g. 3 flashes
equal 3 seconds/minutes).
• Having counted the number of flashes to be set, release button 'S' and the change will be saved.
Understanding when the Air4 Universal Receiver memory is full
When a newly copied code does not work, LED L1 illuminates and LED L2 flashes. In this situation,
delete a remote control no longer in use.
The Air4 Universal Receiver is compatible with Air4 Home and Air4 Home Pro.
Copyright Silca S.p.A 2020. All right reserved
E n g l i s h
9