BGS technic 40100 Manual De Instrucciones página 5

GENERAL
The multi-tester is made for test at 6 to 24 volt electrical systems in vehicles.
The multi-tester is very easy and fast to use and avoid unnecessary expenditure of time.
A search for suitable ground and positive supply connected through long cables.
An LED lamp provides sufficient light in the tip area. The device allows you to:
•
Polarity determination (LED)
•
Check for open or closed circuit.
•
Activating the components with positive or negative current.
•
Voltage test (LED display)
•
Continuity test
•
Ground testing
Eventually, for the testing and safety purpose, Auto Circuit Tester contains short-circuit protection,
which can also check the ground connection without voltage drop tests, The short-circuit protection
system contains the recoverable fuse, and so the technician will not waste the fuses during the
testing. The extension cable with Auto Circuit Tester is long enough for a technician to test the whole
system for the vehicle, therefore, the technician do not have to search for ground connection
constantly.
IMPORTANT
Please read the instruction before you start to use Auto Circuit Tester.
WARNING
When current is provided to the Auto Circuit Tester, spark may be occurred when the tip contacts with
ground or certain circuits. Therefore please do not operate Auto Circuit Tester around flammable. And
do not operating Auto Circuit Tester with 110/220 volt house voltage as it is only for 6-24 volt systems.
IMPORTANT
Please operate this function with schematic and correct testing procedure because applying voltage
arbitrarily may cause damage to components.
If you make a component power, press the switch of the multi-tester before touching the component
with the probe. This way you increase the lifetime of the switch.
BGS technic KG
Bandwirkerstr. 3
D-42929 Wermelskirchen
KFZ-Multitester
Tel.: 02196 720480
Fax.: 02196 7204820
mail@bgs-technic.de
Art. 40100
www.bgstechnic.com
© BGS technic KG, Copying and further use not allowed