BGS technic 40100 Manual De Instrucciones página 6

Test de circuitos electricos
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

INTRODUCTION
1. Probe
2. Ground cable
3. Minus clamp
4. Plus clamp
5. Connection cable
6. Polarity switch
7. Extention cabel
Power Connection
Hook up the black power clip to the
negative of the vehicle battery.
Hook up the red power clip to the
positive of the vehicle battery.
Self-Test
If the Auto Circuit Tester is working
correctly, the condition should be followed :
Red LED should be on when the
technician push the polar switch
forward (toward the positive side).
Green LED should be on when the
technician push the polar switch
backward. (toward the negative side).
Polarity Test
If the Auto Circuit Tester tip is contacting
with positive pole, the red LED lights.
If the Auto Circuit Tester tip is contacting
with negative pole, the green LED lights.
If the Auto Circuit Tester tip is contacting
with open circuit, neither LED lights.
Conductivity Test
By using Auto Circuit Tester tip assisting
with ground test lead, technician can test
the conductivity between wires or
components which has been disconnected
from the vehicle electrical system. If the
current is conductible between wires or
components, the green LED lights.
BGS technic KG
Bandwirkerstr. 3
D-42929 Wermelskirchen
8. Adapter for vehicle socket
9. Adapter for Battery
10. Extention cablel
Tel.: 02196 720480
Fax.: 02196 7204820
mail@bgs-technic.de
LED Light for sufficient light
to illuminated probe area.
www.bgstechnic.com
© BGS technic KG, Copying and further use not allowed

Publicidad

Tabla de contenido
loading

Tabla de contenido