Bayside Furnishings MAR3N1C Instrucciones De Ensamble página 13

NOTE: The tipping restraint hardware included is for drywall construction. It will be necessary to drill
holes for the wall anchors. Depending upon your wall construction, different anchor hardware
maybe required. Please contact your local hardware store for assistance.
17. Position the assembled stand at the desired location against a wall. If necessary, adjust the pre-attached
Floor Levelers at the bottom of the Legs to level the unit. Now, follow the instructions printed on the
plastic bag containing the Tipping Restraint Hardware to attach the tip-over restraint to the Spine and the
wall.
NOTE: YOU MUST USE THIS TIPPING RESTRAINT TO ATTACH THIS UNIT TO THE WALL, TO
PREVENT THE UNIT FROM TIPPING, CAUSING ACCIDENTS AND/OR INJURIES.
18. The stand is now ready for use. Be sure to position your Flat Panel TV in the center of the stand.
NOTE: If you choose the Tilting Wall Mount configuration, proceed to PAGE 22.
Assembly Instructions for Table-top
F
13
TV
F/G
G
E