Bayside Furnishings MAR3N1C Instrucciones De Ensamble página 23

Assembly Instruction for installing the Mounting Frame onto BRICK, SOLID
NEVER use the wall anchors to mount the unit to drywall.
NOTE: If you are mounting your TV to a wall with wooden studs, skip this section. This assembly
requires an electric drill and level (not included).
37. Begin by placing the Mounting Frame (J) level against the wall where you intend to mount the TV. Using
the Mounting Frame (J) as a template, mark 4 drill points with a pencil.
38. With an electric drill (not included) on its low setting, drill 11 mm / .4 in diameter holes to at least
63.5 mm / 2.5 in deep. Insert the Concrete Anchors (KK) into the pre-drilled holes so that they are flush
with the wall.
39. Place the Mounting Frame (J) level in the desired position against the wall. Secure the Mounting Frame (J)
to the wall with the Lag Bolts (II) and the Washers (JJ) at the drill points. Tighten the bolts firmly but be
careful not to over-tighten.
CONCRETE OR CONCRETE BLOCK WALLS
2.50" (63 mm)
Maximum weight 61.2 kg / 135 lb
Concrete Anchors should only be used for masonry mounting.
23
E