Operating Your Halo Uv-St Ultraviolet Vacuum - Halo UV-ST Manual Del Propietário

Operating Your Halo UV-ST Ultraviolet Vacuum

It's time to discover what your new Halo
Have your Halo
through the basics of what you need to know to experience Halo
• Attach the handle to the main shaft of the unit and use the Assembly tool to
screw in the screw on the bottom of the aluminum tube of the handle, as shown
in Illustration 2 on Page 5.
• Make sure the Halo
and the UV-ST bag is zipped completely shut.
• Never operate the product without a proper filter bag securely in place because
it can spray dust and debris out into the room.
• Plug in the power cord — and when you're ready to operate your Halo
Ultraviolet Vacuum, depress the handle release pedal on the left side of the
product base and lean the handle back gently to a comfortable operating
position. You should never use your Halo
and locked position.
• Then to turn the product on, press the ON/OFF button on the top of
the handle. Notice the second button on the handle that turns the
brush ON/OFF, allowing you to vacuum with the brush ON for maximum
suction and cleaning, or turn the brush OFF for non-carpeted floors
and sensitive rugs and carpets.
• Pressing the handle release pedal a second time will allow your Halo
be fully reclined to a near horizontal position. This position will allow access to
low, hard-to-reach areas.
UV-ST Manual Full012.07.indd 11
Ultraviolet Vacuum handy as you read this, and we'll walk you
™
Ultraviolet Vacuum disposable dust filter bag is in place
™
Ultraviolet Vacuum can do!
™
Ultraviolet Vacuum in the upright
™
06
clean.
™
™
UV-ST to
™
12/21/07 8:14:34 PM