Kenmore 580.72077 Manual Del Propietário página 7

I_ Select the position that will place the sill supports
near the outermost point on sill (FIG. 10).
Attach the sill supports to the cabinet track hole
closest to the selected position using screw (ITEM E).
I_ Place the sill supports with the cabinet on the
window sill's selected position (FIG. 10).
iTEM E
FIG. 14
[] DRAINAGE
Be sure to insert the drain pipe into base pan before
installation.
The air conditioner must be installed with a slight tilt
downward to the outside for proper water drainage.
The air conditioner will drain the excess condensed
water through the drain pipe. (FIG. 15)
_1'_ The cabinet should be installed with a very
slight tilt (about 1/4") downward to the outside
(FIG. 11).
Adjust the bolts and the nuts of sill supports to level
the cabinet.
\
ITEM B
FIG. 11
_111Attach the cabinet to the inner sill by driving the
screws (ITEM F) through the lower guide into
window inner sill (FIG 12).
Track
Lower Guide
ITEM F
FIG. 12
ITEM B
_] Pull each side curtain fully to each side of
window opening. Attach each side curtain to the
window sash using screws (ITEM G). (FIG. 13)
. ITEM G
_J_ FIG. 13
i'l_ Attach the L BRACKET (ITEM J) with screw
(ITEM G). (FIG. 14)
DRAIN PIPE
PANBO]qOM
FIG, 15
_J Slide the air conditioner into the cabinet. (FIG. 16)
CAUTION: For security purposes, reinstall side
screws you removed in step 1.
-7-
Screw
•Power
Cord
/
Screw FIG. 16
_1"_ Cut the foar_ seal (ITEM H) to the proper
length and insert between the upper window sash
and the lower window sash. (FIG. 17)
FIG. 17
_'_ The vent controT handle must be straightened
before the decorative front is attached.
Pug down part _)to align with part _,
Part (_
FIG. 18