Installation; Hew To Install; How To Install - Kenmore 580.72077 Manual Del Propietário

INSTALLATION
Pick a location which will allow you to blow the cold air
into the area you want. Windows used for installation
must be strong enough to support the weight of the air
conditioner. Good installation with special attention to
the proper position of the unit will lessen the chance
that service will be needed.
When cooling more than one room, installation location
is very important, if air conditioner is blocked by a
storm window frame, see step 19 on page 8 before
beginning to install. To cool your rooms, cold air must
be blown from the air conditioner in a straight path.
HOW TO INSTALL
B Remove the screws which fasten the cabinet at
both sides and at the back. Save side screws.
Discard back screws.
FIG. 3
[]Slide the unit outof the cabinet by gripping the base
)an handle and pull forward while bracing the cabinet.
FIG. 4
_1 Cut the FOAM STRIP (ITEM I) to fit the
underside of the window sash. Peel off the backing
and attach the FOAM STRIP as shown in Fig. 5.
FIG. 5
_! Insert the side curtain (ITEM A) into the upper
guide and lower guide of the air conditioner. Fasten
the curtains to the unit with screws (ITEM E).
ITEM E
ITEM E FIG. 6
O Open the window. Mark a line on center of the
window inner sill. Carefully place the cabinet on the
window inner sill and align the center of the cabinet
front with the center line marked in the window inner
sill.
Window s ill
FIG, 7
r_ Pull the bottom window sash down behind the
upper guide until they meet.
NOTE: Do not pull the window sash down so tightly
that the movement of side curtain is restricted.
Window sash
Cabinel
Side Curtain
FIG. 8
[] Loosely assemble the sill supports using the
parts in FIG. 9.
ITEM 8
ITEM C _'e'-= _ITEM [3
FIG. 9
-6-