Bluetooth; Bluetooth Operation - SSANGYONG AGC-9145BY/WY Manual Do Usuário

Bluetooth

▶ Bluetooth operation

To use the Bluetooth function, the following procedure is necessary.
1. Pairing
When connecting Bluetooth devices for the first time, mutual
registration is required. This is called "pairing.". This registration
(pairing) is required only for the first time, as this unit and the other
devices will recognize each other automatically from the next time.
(Depending on the device, you may need to input a pass code for
each connection.)
2. Connection
Sometimes pairing allows automatic connection.
To use the device after pairing is made, start the connection.
3. Handsfree talk/Music streaming
You can call a mobile phone and listen to music when the connection
is made.
Some Bluetooth device may not support specific functions.
▶ Pairing your phone and car audio system
Fist, register ("pair") a Bluetooth device (mobile phone, etc.) and this unit with
each other. You can pair up to 6 devices. Once pairing is established, there is no
need for pairing again.
Place the Bluetooth device within 3 m (9 ft) of this unit.
1
Press and hold CALL [
seconds.
The unit enters pairing standby mode. The "PAIRING"
appears in the display with beep and then flash the
"KEY 00xx".
2
Set the Bluetooth device to search for this unit.
A list of detected devices appears in the display of the connecting
device. This unit is displayed as "New Rexton" or "SSANGYONG"
on the connecting device.
Confirm this by pressing "YES" or "OK" on your phone.
14
AGC-9145BY/WY AGC-9146BA/WA
3
4
▶ Connecting a mobile phone
] button for more 3
- If your phone does not find "New Rexton" or "SSANGYONG" repeat steps
1~2.
If *Pass key input is required on the display of a connecting
device, input "00xx" (4 digit).
This unit and Bluetooth device memorize each other's information,
and when pairing is made, the unit is ready for connection to the
device.
"BT CONNECT" and "Bluetooth device model name" or "BT
MOBILE" with " " indicator appear after pairing is completed.
- Some Bluetooth device ask you to accept the "BT link" or "Connect".
Enter "Yes" or "OK".
* Pass key may be called "passcode," "PIN code," "PIN number" or
"password," etc., depending on the device.
Set the Bluetooth device to connect to this unit.
Note : Pairing standby mode is not released until the connection is made.
- Devices are registered once paired and connected with this unit. You
can select the registered device and connect it.
- If pairing has already been achieved, start operation from here.
- Depending on the device, connection may start automatically after pairing.
1
Connect to this unit using your mobile phone and
press CALL [
The "BT CONNECT" with " " icon is appeared and
Bluetooth signal is switched to on.
Note
To show the information of connected Bluetooth
device, press SCAN/INF button .
] button .