Preparation; Operating Instructions - Kobalt KOS 2450B-03 Manual De Instrucciones

PREPARATION

Know Your Random Orbit Sander
This sander can be used for the purpose listed: sanding wood and wood product surface.
Before attempting to use the sander, familiarize yourself with all of its operating features and
safety requirements.
WARNING
• Do not allow familiarity with the tool to cause carelessness. Remember that one careless
moment is enough to cause severe injury. Before attempting to use any tool, be sure to
become familiar with all of the operating features and safety instructions.
• Do not attempt to modify this tool or create accessories not recommended for use with this
tool. Any such alteration or modification is misuse and could result in a hazardous condition
leading to possible serious personal injury.

OPERATING INSTRUCTIONS

1. To Attach Battery Pack
a. Make sure that the ON/OFF switch (A) is in the
OFF position (the O button is depressed).
b. Align the raised portion on the battery pack (not
included) with the grooves on the bottom of the
tool, and then slide the battery pack onto the
tool as shown.
c. Ensure that the battery-release buttons on the
battery pack snap into place and the battery
pack is secured to the tool before beginning
operation.
NOTICE: When placing the battery pack on the
tool, be sure that the raised rib on the battery pack
aligns with the groove on the tool and the latches
snap into place properly. Improper attachment of
the battery pack can cause damage to internal
components.
To Detach Battery Pack
a. Make sure that the ON/OFF switch is in OFF
position (the O button is depressed).
b. Press the battery-release buttons to release the
battery pack.
c. Pull the battery pack to remove it from the tool.
WARNING
• Battery tools are always in operating condition.
Therefore, the ON/OFF switch should always be
in the OFF position when the tool is not in use or
when carrying the tool at your side.
1a
A
1b
7