Hinkley 980013FAS Instrucciones De Instalación

Control is compatible with 6 speed DC fans
GENERAL INFORMATION
This wall remote control is designed to separately control your ceiling fan speed and light brightness.
The fan button will control the fan's 6 speeds from highest to lowest speed.
The light buttons will control the lights, brightness dimmer and off. The "D" selection is the
light on only (no dimming function) and is to be used with CFL bulbs.
The red indicator on the transmitter will light when the button is pressed.
INSTALLATION AND OPERATING INSTRUCTIONS
NOTE: This unit is equipped with automatic learn mode capability. There is no frequency switches.
NOTE: Remove the panel from the transmitter and then install one 23A/12V battery (included). To prevent damage to transmitter, remove the
battery if not use for long periods of time (Fig. A).
Fig. A
1. INSTALLING THE WALL TRANSMITTER
a. Remove the existing wall plate and the old switch from the wall outlet box. (Fig. B)
b. Wire nut the two BLACK leads from outlet box to the two BLACK leads from the Transmitter. If your outlet box has a ground wire (Green
or Bare Copper) connect the Transmitter's ground wire directly to one of the screws from the outlet box. Secure all wire connections with
the plastic wire nuts provided. (Fig. C)
c. Carefully tuck the wire connections inside the outlet box. Use the screws provided to secure the wall transmitter and wall plate to the outlet
box. (Fig. C)
Outlet box
Fig. B
Remove the
decorative cover
Transmitter
Switch
Wall plate
6 SPEED FAN & LIGHT WALL REMOTE CONTROL
INSTALLATION INSTRUCTIONS
Transmitter
Fig. C
Decorative Wall Plate