Hardware Assign - HEADRUSH MX5 Guia De Inicio Rapido

Hardware Assign

The Hardware Assign screen enables you to
customize how HeadRush MX5's footswitches and
an expression pedal control each rig.
To open the Hardware Assign screen, tap the 
button in the upper-right corner of the main screen,
and then tap Hardware Assign.
To return to the main screen, tap the  button in
the upper-left corner.
Important: The Hardware Assign settings are all part
of the overall rig, so remember to save your
changes you want to keep.
To set the color associated with the rig, tap it in the upper-left part of the screen. This color
will appear next to the rig name when you view a list of all available rigs or when you view and
create setlists. It will also be the color of the corresponding footswitch indicator when HeadRush
MX5 is in Rig Mode.
To set the tempo of the rig's time-based effects (delays, modulation, etc.), tap the button
under Tempo to select Current or Fixed.
•
Current: The rig will use the last-used tempo or the one set by the Tempo footswitch.
To set the tempo, press the Tempo footswitch at the desired tempo 3–8 times to set the
new tempo in beats per minute (BPM).
•
Fixed: The rig will use a tempo that you set here.
To set the tempo, turn the encoder to set the desired tempo in beats per minute
(BPM). You can set the tempo only in this Hardware Assign screen.
To load a rig when a MIDI program change is received from an optional external MIDI
device, or to send a MIDI program change message when a rig is loaded, tap the button
under MIDI, and then turn the encoder to select a MIDI program change number. You can
adjust whether MIDI program changes are received and/or sent in the Global Settings menu.
Note: If a rig is using a number, that number will be unavailable and cannot be assigned to
another rig. Additionally, saving a rig with a new name will save the rig but without the program
change number to prevent rigs from sharing the same number.
Footswitches
The 3 boxes in the lower-left corner represent the 3 footswitches of HeadRush MX5. You can
assign any switch-based parameters (ones with only two states) to any of the footswitches—
regardless of their location in the signal chain.
To assign a parameter to a footswitch:
Tap a box.  indicates an empty box.
1.
2. In the list that appears, tap the model with the
parameter you want to assign.
3. In the list that appears, tap the parameter you
want to assign. Usually, the parameter will
simply be On (to activate or deactivate it).
Tap Unassigned
footswitch.
To swap two assignments, tap and drag one of them over the other, and then release it.

to unassign that
11