Graham Field LUMEX 7921RA Manual De Instrucciones página 2

2. Place the seat facedown on a flat surface.
3. Locate the four legs.
4. Install legs on frame: press lock button on each
plastic leg sleeve end and slide the leg onto the
frame until the button clicks into place.
5. Adjust leg extension height by pushing in the leg
height adjustment lock button, moving to the
desired hole height, and releasing button until it
clicks into place.
Info: If assembling 7921RA (with backrest),
proceed to step 6.
If assembling 7931RA (without backrest),
proceed to step 9.
6. Locate backrest tubes and backrest.
7. Install backrest tubes on backrest: press each
backrest tube lock button and slide tube onto
backrest until button clicks into place.
8. Install backrest on bath seat: press both backrest
lock buttons and slide backrest tubes into bath
seat backrest channel guides until buttons click
into place.
9. Attach arms: press both arm lock buttons and
insert each arm into arm socket until arm clicks
into place.
WARNING: Ensure all lock buttons have clicked into place and all lock buttons protrude
fully through holes. Contact your GF authorized distributor immediately if you see any
issue with fit, form, function, or safety.
WARNING: Ensure the Bath Seat is assembled as described. If the Bath Seat is not properly
assembled and installed, personal injury and damage to the Bath Seat could result.
7921RA-INS-LAB-RevC19
step 7
step 8
step 9
step 4
step 5
7921RA Bath Seat
with Arms and Backrest
2