Publicidad
Enlaces rápidos
AUTOMOTIVE PRODUCTS, INC.
STEP BAR ASSEMBLIES
ENSAMBLES DE ESTRIBOS
MONTAGES DE MARCHE-PIEDS
23-0925
23-0930
ITEM
QTY
1,2
2
STEP BAR, PASSENGER (1) AND DRIVER (2)
3,4
2
FRONT BRACKET, PASSENGER (3) AND DRIVER (4)
5,6
2
REAR BRACKET, PASSENGER (5) AND DRIVER (6)
7
4
1/2-13 X 1.75" HEX HEAD BOLT
8
4
1/2" FLAT WASHER
9
4
1/2" LOCK WASHER
10
8
M8 HEX HEAD BOLT
11
16
M8 FLAT WASHER
12
8
M8 LOCK WASHER
13
8
M8 HEX NUT
14
4
M8 SELF THREADING, FLANGE HEAD BOLT -
1,2
2
ESTRIBOS, LADO DEL ACOMPAÑANTE
3,4
2
SOPORTES
5,6
2
SOPORTES
7
4
PERNOS CON CABEZA HEXAGONAL DE 1/2-13 X 1,75"
8
4
ARANDELAS PLANAS DE 1/2"
9
4
ARANDELAS DE PRESIÓN DE 1/2"
10
8
PERNOS CON CABEZA HEXAGONAL DE M8
11
16
ARANDELAS PLANAS DE M8
12
8
ARANDELAS DE PRESIÓN DE M8
13
8
TUERCAS HEXAGONALES DE M8
14
4
PERNOS AUTOROSCANTES CON CABEZA DE BRIDA DE M8
1,2
2
MARCHE-PIEDS, PASSAGER
3,4
2
SUPPORT AVANT
5,6
2
SUPPORT ARRIERE
7
4
BOULON A TETE HEXAGONALE 1/2-13 X 1,75 PO
8
4
RONDELLE PLATE 1/2 PO
9
4
RONDELLE A FREIN DE 1/2 PO
10
8
BOULON A TETE HEXAGONALE M8
11
16
RONDELLE PLATE M8
12
8
RONDELLE A FREIN M8
13
8
ÉCROU HEXAGONAL M8
14
4
BOULON AUTOFILETEUR A TETE HEXAGONALE A EPAULEMENT M8
STEP 1. Remove the contents from box and check for damage. Verify all parts are present. Read instructions completely before beginning.
STEP 2. Determine front and rear brackets. The front brackets have seven slots. SEE FIGURE 2.
STEP 3. Remove black tape over two holes on inside face of rocker panel. Attach front brackets with downward sloping end towards front using
M8 fasteners as shown. Place bolts through holes as shown. SEE FIGURE 2. Leave loose. NOTE: 2003-UP models use hole pattern
towards back end of bracket. 2007-UP Expedition EL models use hole pattern toward front end of bracket. SEE FIGURE 2.
STEP 4. Attach rear brackets with downward sloping end towards rear using M8 fasteners as shown. Place bolts through holes as shown. SEE
FIGURE 2. Leave loose.
STEP 5. 1997-2002 models: Install self tapping bolts with 12MM socket into holes previously covered by factory tape. NOTE: Do not use air
tool on this fastener.
INSTRUCTIONS-INSTRUCCIONES-CONSIGNES
APPLICATION:
APLICACIÓN:
APPLICATION:
1
CONTENTS -
CONTENIDO
(1)
DELANTERAS,
LADO DEL ACOMPAÑANTE
TRASERAS
,
LADO DEL ACOMPAÑANTE
(1)
ET
CONDUCTEUR (2)
, PASSAGER
(3)
ET
CONDUCTEUR (4)
, PASSAGER
(5)
ET
CONDUCTEUR (6)
1997-2007 FORD EXPEDITION; 2007 FORD EXPEDITION EL
FORD EXPEDITION, MOD. 1997-2007, FORD EXPEDITION EL, MOD. 2007
FORD EXPEDITION 1997-2007; FORD EXPEDITION EL 2007
- CONTENU
Y EL CONDUCTOR
(2)
(3)
Y EL CONDUCTOR
(5)
Y EL CONDUCTOR
ECO# W11-0128:
3
2
5
TOOLS -
HERRAMIENTA
12MM SOCKET
3/4" WRENCH
3/4" SOCKET
13MM SOCKET
13MM WRENCH
RATCHET
TORQUE WRENCH
DADO DE 12MM
(4)
DADO DE 3/4"
(6)
LLAVE DE TUERCAS DE 3/4"
DADO DE 13MM
LLAVE DE TUERCAS DE 13MM
MANERAL
LLAVE DE TORQUE
CLE 12MM
DOUILLE 3/4 PO
CLE 3/4 PO
DOUILLE 13MM
CLE 13MM
CLIQUET
CLE DE COUPLE
75-0282 REVISION A 2/21/12
4
6
- OUTILS
Publicidad
Manuales relacionados para Westin 23-0925
Resumen de contenidos para Westin 23-0925
- Página 1 FORD EXPEDITION, MOD. 1997-2007, FORD EXPEDITION EL, MOD. 2007 APPLICATION: FORD EXPEDITION 1997-2007; FORD EXPEDITION EL 2007 AUTOMOTIVE PRODUCTS, INC. STEP BAR ASSEMBLIES ENSAMBLES DE ESTRIBOS MONTAGES DE MARCHE-PIEDS 23-0925 23-0930 ITEM CONTENTS - CONTENIDO - CONTENU TOOLS - HERRAMIENTA...
- Página 2 FINISH PROTECTION Westin products have a high quality finish that must be cared for like any other exposed finish on the vehicle. Protect the finish with a non-abrasive automotive wax, (e.g. Pure Carnauba) on a regular basis. The use of any soap, polish or wax that contains an abrasive is detrimental, as the compounds scratch the finish and open it to corrosion.
- Página 3 FIGURA 2 VISTA DE LA INSTALACIÓN DEL LADO DEL CONDUCTOR OPUESTO AL LADO DEL ACOMPAÑANTE FIGURE 2 ILLUSTRE: COTE CONDUCTEUR, EN FACE: COTE PASSAGER Thank You for choosing Westin products Westin Automotive Products, Inc. For additional installation assistance please call 5200 N.