allen+roth WSWS-VWU1C Manual De Instrucciones página 7

ASSEMBLY INSTRUCTIONS
Step 5
Wood support assembly
M3.5 x 12 mm
FF
Wood screw
NOTE: Attach the wood support
(G) to inside of the unit as a
reinforcement for attaching the
expandable pole kit (sold
separately) at the opposite side.
Please place the pole holder at
the middle of the wood support.
Please disregard this step if you
only serve the unit as a single
tower.
Step 6
Wall Hanging installation
II
M8 x 2-1/2 in. Lag Bolt
x 4
JJ
Large Flat Washer
Position the provided installation
template (H) on desired location
and carefully follow the directions
on template to mark the installing
holes. Make sure the bottom two
installing holes location are more
than 30 ½ in. from the floor. Drill
holes 2-1/2 in. deep with a 3/16 in.
drill bit at the marked location.
x 8
x 4
Minimum 30 ½ in.
(77.47 cm)
G
FF
Expandable pole kit
(sold separately)
Wooden Stud
16 in.
(40.6 cm)
40.6 in.
(103.2 cm)
Installation
Template
7
G
Installing Hole
JJ
II
A
Beveled edge
facing up
JJ
II
A