Publicidad
Idiomas disponibles
Idiomas disponibles
Installation and servicing (Dwg. 1–5)
Caution! Before installing and servicing the fan, please
disconnect the mains power.
Caution! Only an electrician specialist may carry out installation
and servicing.
The fan can be mounted directly in the duct. Before mounting, please check the air duct for
damage. When mounting, please ensure that the white arrow on the housing of the fan points in
the same direction that the air is flowing. A hanger should be used for mounting. After mounting
the fan, you should make sure that it is attached firmly and is not at risk of falling during use. The
switch must be selected according to the electrical characteristics included in the Technical Data
Sheet. The switch must be integrated into the fixed wiring powering the fan.
It is recommended to clean the propeller and housing of the fan every six months. Cleaning must
be performed by using a dry, soft brush or compressed air. Please clean carefully in order not to
affect the balance of the propeller. It is prohibited to clean the propeller by using chemical agents or
cleaners. During cleaning, it is prohibited to immerse the motor in water or any other solutions.
In case of damages:
1. Check if the electric current is supplied to the device.
2. Ensure that the impeller is not blocked.
3. Check the capacitor (for single-phase fans – according to the connection scheme). If the
problem persists, replace the capacitor.
4. If this does not help, it is necessary to contact the supplier
Guarantee
Producer guarantee is 24 months.
In the case of damages contact the place of trade.
The guarantee does not cover:
1. noted mechanical or other damages
2. mechanical or other damages caused by incorrect or improper usage, misuse, abuse or
neglect
3. mechanical or other damages caused by incorrect installation or by product's incorrect
fitting to insufficient or unsuitable power
4. mechanical or other damages caused by ignoring the instruction manual conditions
A guarantee does not cover natural wear of the product.
Information for Users on Disposal of Old Equipment. This symbol indicates
that the electrical and electronic equipment should not be disposed of as
general household waste at its end-oflife. Instead, the products should be
handed over to the appliance collection points for the recycling of electrical
and electronic equipment, recovery and recycling in accordance with your
national legislation and the Directive 2002/96/EC and 2006/66/EC.
45
EN
Publicidad
