Tabla de contenido
Publicidad
Copyright © 2019 TELTONIKA Ltd. all rights reserved. Reproduction, transfer, distribution or storage of part or all of the
contents in this document in any form without the prior written permission of TELTONIKA Ltd is prohibited. The manufac-
turer reserves the right to modify the product and manual for the purpose of technical improvement without prior notice.
Other product and company names mentioned herein may be trademarks or trade names of their respective owners.
To avoid voltage caused traumas please follow these safety requirements:
- The device is intended to be powered from Limited Power Source (LPS) with a power of at least 18 W.
- The overcurrent protective device rated current should not exceed 3A.
- The highest transient overvoltage in the output (secondary circuit) of used PSU shall not exceed 55 V peak.
- The device can be used with a Personal Computer (first safety class) or Notebook (second safety class). Associated equipment:
PSU (power supply unit) (LPS) and personal computer (PC) shall comply with the requirements of standard EN
60950-1/EN 62368-1.
- To avoid mechanical damage to the device it is recommended to transport it packed in a damage-proof pack.
When using the device it should be placed so that its indicating LEDs would be visible as they inform in which working mode the
device is in and if it has any working problems.
Protection against over current, short circuiting and earth faults should be provided as a part of the building installation.
LEGAL NOTICE
ATTENTION
SAFETY
Publicidad
Tabla de contenido
