Corsair STRAFE RGB MK.2 Manual De Instrucciones página 4

3
HARDWARE PLAYBACK
The 8MB of onboard memory allocated for up to three profiles stores complex
actions or custom lighting which can be executed without additional software.
Complex macros or key remaps as well as custom lighting effects can be created and
saved back to onboard storage using CUE software. Use Profile Switch key to cycle
through saved onboard profiles.
PROFILE #1
Spiral Rainbow
PROFILE #2 PROFILE #3
Rain Rainbow Wave
!
NOTE ON ENVIRONMENTAL PROTECTION
After the implementation of the European
Directive 2012/19/EU in the national legal system,
the following applies:
— Electrical and electronic devices may not be
disposed of with domestic waste.
— Consumers are obligated by law to return
electrical and electronic devices at the end of
their service lives to the public collecting points
set up for this purpose of point of sale. Details
to this are defined by the national law of the
respective country. This symbol on the product,
the instruction manual or the package indicates
that a product is subject to these regulations.
By recycling, reusing the materials or other
forms of utilizing old devices, you are making
an important contribution to protecting our
environment.
CAUTION!
The manufacturer is not responsible for any
radio or TV interference caused by unauthorized
modifications to this equipment. Such
modifications could void the user authority to
operate the equipment.
FCC STATEMENT
This equipment has been tested and found to
comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC Rules. These limits
are designed to provide reasonable protection
against harmful interference in a residential
installation. This equipment generates, uses
and can radiate radio frequency energy and, if
not installed and used in accordance with the
instructions, may cause harmful interference
to radio communications. However, there is no
guarantee that interference will not occur in a
particular installation. If this equipment does
cause harmful interference to radio or television
reception, which can be determined by turning the
equipment off and on, the user is encouraged to
try to correct the interference by one or more of
the following measures:
> Reorient or relocate the receiving antenna.
> Increase the separation between the
equipment and receiver.
> Connect the equipment into an outlet on a
circuit different from that to which the receiver
is connected.
> Consult the dealer or an experienced radio/TV
technician for help.
This device must not be co-located or operating in
conjunction with any other antenna or transmitter.
Operation is subject to the following two
conditions:
(1) this device may not cause harmful interference,
and (2) this device must accept any interference
received, including interference that may cause
undesired operation.