RCA AMP1450F Manual Del Usuario

FCC Statement:
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause
harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC
Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment
generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
Caution: Any Changes or modifi cations not expressly approved by the party responsible for compliance could void the user's authority to
operate this equipment.
Industry Canada Regulatory Information
CAN ICES-3 (B)/NMB-3 (B)
Avis d'Industrie Canada
CAN ICES-3 (B)/NMB-3 (B)
This amplifi er helps enhance the performance of all passive indoor antennas. It was engineered
specifi cally for digital signals. It also supports analog signals. This amplifi er:
• Enhances performance of passive antennas in challenging reception situations
• Optimizes signal for the best possible reception through improved gain
• Preserves signal purity with Extremely Low-Noise (ELN) circuitry
Passive
Antenna
antenna
AMP1450R
ANTENNA
TV/STB
TV
©2013 VOXX Accessories Corporation
3502 Woodview Trace, Suite 220, Indianapolis, IN 46268
AMP1450F / AMP1450R / AMP1450FV
Digital Signal Amplifi er For Indoor Antennas
User's Guide
Installing the Amplifi er
1. Make sure your TV or converter box is turned off.
2. Disconnect your antenna from your TV or converter box.
3. Connect the cable coming from your antenna to the input jack
of the amplifi er.
4. Connect the amplifi er's built-in cable to the antenna input on
your TV or converter box.
5. Plug the amplifi er's power cord into an electrical outlet.
Important: This power unit should be plugged in so that it stays vertical
or lies fl at.
6. Turn on your TV or converter box and re-scan for channels.
www.rcaaudiovideo.com
Trademark(s) Registered
Printed in China AMP1450_IB_03
Info
Este
1) E
pue
Se p
con
la in
está
radi
prod
equ
• R
• A
• C
• C
Prec
auto
Info
CAN
El
des
am
• M
• O
• C
AM
am
©20
3502