DeWalt DXGSE Manual Del Operador página 15

ASSEMBLY - Continued
Adjusting the Handle
If the handle requires adjustment:
1. Loosen the bolts slightly (Fig. 4). Use a 5/32-
inch (4 mm) Allen wrench.
2. Hold the unit in the operating position (Fig.
13). Move the handle up or down the upper
shaft housing to a comfortable location (Fig.
5). Make sure the handle is positioned
beyond the end of the safety label (Fig. 5).
3. Tighten the bolts until the handle is secure.
Handle Top
Upper Shaft Housing
Hole (x4)
Handle Base
Upper Shaft Housing
Safety Label
Bolt (x4)
Fig. 4
Fig. 5
15
ENGLISH
Handle