Facom 779.CL2 Guía De Instrucciones página 3

EN
55 mm
SPECIFICATIONS
Weight
Luminosity
In-charge power input
Voltage
Protection rating
Storage temperature
Operating temperature
Battery
779.CL12 Charger
Protection rating
Charging time
Autonomy
Charging temperature
☞
+
EC statement of compliance:
WE, FACOM S.A., 6/8 RUE GUSTAVE EIFFEL - BP 99 - 91 423 MORANGIS CEDEX FRANCE, STATE UNDER OUR LIABILITY THAT THE FOLLOWING PRODUCTS:
779.CL2 – CORDLESS INSPECTION LAMP by FACOM
COMPLY WITH THE PROVISIONS SET OUT IN THE FOLLOWING EUROPEAN DIRECTIVES:
- ''LOW VOLTAGE'' DIRECTIVE 73/23/CEE AMENDED BY DIRECTIVE 93/68/CEE
- ''EMC'' DIRECTIVE 89/336/CEE AMENDED BY DIRECTIVE 93/68/CEE
AND COMPLY WITH THE PROVISIONS SET OUT IN THE FOLLOWING HARMONISED EUROPEAN STANDARDS:
- EN 55015 - EN 55022 - EN 55024
- EN 60598-1 - EN 60598-2-8 - EN 61000-3-2 - EN 61000-3-3 - EN 61547
04
45mm
250 mm
779.CL21
480 g
1000 Lux à 0,5 meter
14 W
7,2 V ----
IP 64 IK 9
-20°C ➙ + 70°C
-10°C ➙ + 50°C
Ni-MH pack batteries 1000 mAh min
100-230 V 50 - 60Hz - 12 VA double insulation output
IP 20
1,5 hours
6 hours (new LEDs and batteries)
5°C ➜ + 45°C
+
OPERATION
-
The maximum autonomy is reached after 3 complete charge-discharge cycles.
-
-
-
-
-
-
-
MAINTENANCE
-
-
-
-
-
-
779.CL2
779.CL21
30.11.04
Quality Manager
Before first use, charge the 779.CL2 inspection lamp for 3 hours.
Power indicator on the base: green LED On.
The LEDs on the lamp blink to indicate charging. Once charging is complete, the LEDs are switched off.
When switched on, the lamp's intensity increases gradually to preserve LED lifetime.
The lamp's light intensity rises gradually when it is turned on to preserve the lifetime of the LEDs.
When the operating time left drops to 1/4 hour, the lamp switches off and switches on instantly every 15 seconds.
Batteries are sensitive to temperature: autonomy variations can occur at low temperatures
The charging system is fitted with an automatic thermal circuit breaker.
779.CL2
The inspection lamp resists to most products and solvents used in automotive
repair and industrial shops (white spirit, petrol, diesel fuel, brake fluid, engine oil).
Never immerse the 779.CL2 inspection lamp in a cleaning product.
Use a dry cloth with soapy water to clean your 779.CL2
Use only FACOM spare battery packs, reference 779.CL16.
Using non-compliant packs or improper usage can cause leaks or an explosion which would damage the lamp.
Use only the 779.CL13 mains adapter supplied by FACOM. Using other mains adapters can cause
electrical hazard and start a fire.
Before any prolonged use of the lamp, perform a full discharge-recharge cycle.
Ni-MH batteries are consumables not covered by the guarantee.
The lamp's autonomy is specified for new batteries.
OPTION
779.CL14
12 V / 24 V
779.CL12
+
+
inspection lamp.
779.CL16
Ni-MH
779.CL13
779.CL16