Checking The Direction Of Rotation - Vertilux Vti 025 Serie Manual De Programación

Pairing the motor with the remote control
1. Press and hold the
head of the motor until the
2. Select the desired channel and press the
up button until the motor "jogs". Now the motor
is paired with the remote control.

Checking the direction of rotation

This function must be done before setting the limits and is convenient when the need arises to
change the rotation of the motor. For example, when pressing the
control, the shade goes down, or when pressing the
1.
Press and hold the
until the motor "jogs".
2. Release the stop button, and press the
button 2 s until the motor "jogs".
for about
The motor has now changed its direction.
Setting the upper limit
The upper limit should be set first. If needed, the upper limit can be adjusted, but it cannot be
deleted. If you need to delete the upper limit, reset the motor to factory default setting and start the
initial programming sequence again.
1. Using the remote, move the shade and stop it
4"
approximately below the desired upper limit
position. Press and hold the
located on the back of the remote until the
motor "jogs".
2. Move the shade up to the desired upper limit
position and then press and hold the
button until the motor
limit is now set.
programming button on the
motor "jogs".
stop button 5 s
for about
down
programming button
programming
"jogs" again. The upper
© 2021. Vertilux, Ltd. All Rights Reserved. Last revised: May 2021.
up button
down button, the shade goes up.
~4"
UPPER
LIMIT
PROGRAMMING
BUTTON
UP
BUTTON
on the remote
STOP
BUTTON
DOWN
BUTTON
PROGRAMMING
BUTTON
PROGRAMMING
BUTTON
vertilux.com
3