Checking The Direction Of Rotation - Vertilux VTi CELTIC RF Manual De Programación

Checking the direction of rotation

This function must be done before setting the limits and is convenient when the need arises to
change the rotation of the motor. For example, when pressing the
control, the shade goes down, or when pressing the
1.
Press and hold the
until the motor "jogs".
2. Release the stop button, and press the
button 2 s. The motor has now changed
for about
its direction.
Setting the upper limit
The upper limit must be set first and cannot be erased or modified once it has been set. If you
have made a mistake setting the upper limit, reset the motor to factory default setting and start
the initial programming sequence again.
1.
Using the remote, move the shade and stop it
approximately 4" below the desired upper limit
position. Press and hold the
located on the back of the remote until the
motor "jogs".
2. Move the shade up to the desired upper limit
position and then press and hold the
button until the motor
limit is now set.
Setting the lower limit
1.
Using the remote, move the shade and stop it
approximately 4" above the desired lower limit
position. Press and hold the
located on the back of the remote until the
motor "jogs".
2. Move the shade down to the desired lower limit
position and then press and hold the program
button until the motor
limit is now set.
vertilux.com
4
© 2018. Vertilux, Ltd. All Rights Reserved. Last revised: October 2018.
stop button 5 s
for about
down
programming button
programming
"jogs" again. The upper
programming button
"jogs" again. The lower
up button
down button, the shade goes up.
~4"
UPPER
LIMIT
~4"
LOWER
LIMIT
on the remote
STOP
BUTTON
DOWN
BUTTON
PROGRAMMING
BUTTON
PROGRAMMING
BUTTON
PROGRAMMING
BUTTON
PROGRAMMING
BUTTON