Set-Up Instructions - NORTH STATES 8657 Manual De Instrucciones

INSTRUCTIONS FOR INSTALLING SKID-RESISTANT PADS
Your North States enclosure can be used on hard surfaces (hardwood oors, tile, linoleum, etc.) by
installing the enclosed skid-resistant pads.
1. Ensure that the surface of the yard panel is clean and dry prior to installing the pads.
2. Remove a single pad from the release paper as shown in FIGURE 2.
3. Place the adhesive side of the pad on the bottom edge of the yard panel approximately 2" from the
center of each hinge, as shown in FIGURE 3.
4. Repeat steps 2 & 3 for each of the remaining pads.
5. Maximum skid-resistance will be maintained by cleaning the bottoms of the pads periodically with a
water-dampened clean cloth.
FIGURE 2

SET-UP INSTRUCTIONS

Begin setting up your enclosure by unsnapping
the gray carrying strap and carefully unfolding the
panels to the proper configuration on page 2.
(NOTE: Model 8799 consists of eight panels which
will form an octagon when set up properly. Model
8807 consists of four panels which form a square.)
Once the panels are unfolded and formed into the
(unconnected) shape of a hexagon/octagon/
square, confirm that the dark gray carpet foot (D)
is facing upwards, as shown in FIGURE 4.
Begin connecting the panels together by gently
lifting up on panel 1 and setting the opening "A"
(as shown in FIGURE 5) over pin "B" located on
panel 2.
Locate the slot on the lower end of cylinder "D" as
shown in FIGURE 6. This slot tapers to an opening
that accommodates pin "C".
Gently press down on panel 1 while aligning pin
"C" with the slot in cylinder "D". While maintaining
downward pressure on panel 1, lift slightly on
panel 2, and slide pin "C" through the slot and into
the opening as shown.
EXTENSION INSTALLATION
Some models have two-panel extensions that are colored appropriately for your yard and are available
either from your retailer or direct from www.northstatesind.com
The extension contains two additional panels that enable you to expand the size of your enclosure
from 18.5 square feet to 34.4 square feet.
The extension is installed by following the "SET-UP INSTRUCTIONS" that appear above.
FIGURE 3
FIGURE 4
PANEL 1
P
FIGURE 5
PANEL 1
OPENING A
D
Dark Gray
Carpet Foot
C
A B
FIGURE 6
PANEL 2 PANEL 1
PIN B
PIN C
Page 3
PANEL 2
PANEL 2
SLOT IN
CYLINDER D