MPB 8 L/R Instrucciones De Montaje página 3

inside
1 – table top
2a – countersunk screw M6 x 50 mm
2b – countersunk screw M6 x 55 mm
3 – spacer / distance piece
4a – height correction 5 mm
4b – height correction 2,5 mm
1. The therapy table consists of 3 packages: table top (1), angle- and holding rails (3, 5, 8, 9)
as well as the accessories bag with screws, distance pieces, washers, knurled and cap
nuts.
2. Please make sure that the assembly place is absolutely clean and soft. Remember that
little pieces, splinters, shavings or similar could scratch the table top (1).
3. First, decide if you want to assemble the therapy table left or right sided in driving direction.
Remove only the downwards showing protection foil of the table.
4. Assemble the angle rail as shown in the sketch or picture.
Insert first the countersunk screw (2b) into the outer holes of the table top (1) and on that
place the distance piece (3). The chamfer of the distance piece (3) points inside of the
back. Possibly you need the height correction for the armrests (4a + b). On that put the
angle rails (5) followed by one plastic washer each (6) and the knurled nuts (7).
Assembly instruction for
TRAY UNILATERALLY 8 L/R
for laying the arm on
Only for using on side parts of standard wheelchairs
2a
1
8
9
6
10
outer edge
2b
3
4
7
5
6
5 – angle rail
6 – washer
7 – knurled nut
8 – inclination equalizing bar
9 – holding rail
10 – cap nut
Photo similar